EBC Prolite floating brake discs, as used on our K race bikes. Suitable for road or race. MADE IN THE UK.
Available for :BMW K1/K75/K100/K1100
The aim of the development is to improve the braking behavior compared to the original brake disc. EBC uses HPSR steel with a low carbon content, which has an 18% higher friction coefficient. This steel is much more resistant to rust than cast steel. In addition, the entire surface is protected by a 3 micron thick zinc layer, which is braked in the area of the brake lining contact zone when braking. It is only in this area that it is easier to form rust rust with a longer service life.
The brake discs are drilled in the bird's-swing signal to get rid of the rainwater and brake dust with as few holes as possible while simultaneously cleaning the brake disc. The fewer drill holes are installed, the better the wet braking behavior and the lower the wear.
Brake ring made of forged HPSR steel with low carbon content.
No warping of the brake disc even at the highest load.
No glazing of the braking surface, therefore the coefficient of friction remains constant.
Braked surface with optimized hole pattern.
Galvanized to protect against corrosion.
Anodized aluminum hub.
Lowest manufacturing tolerances.
EBC recommends for best braking performance EBC Double-H sintered brake pads.
Stand-alone design.
Manufacturer: EBC - Made in the U.K. 
£142.80 INC VAT £119.00 EX VAT
Please make your selection below:
Also available for other makes and models contact us with your requirements.
